RTC on DaVinci based board.

[Amol Lad]

You do not need to write any kernel driver - you can
do this in user space. You can use routines in below
link to access your I2C device

http://elinux.org/I2Croutines.c

So, read the data sheet, use above routines and
access/configure necessary registers


--- Jitendra <jitendra.jain at einfochips.com> wrote:

> Hello all,
> I am using DaVinci based custom board.
> We are using M41T81S RTC chip.
> Can anyone guide me how to make driver for above
> chip and how to
> configure it via I2C?
>  
> Thanks in advance.
> > _______________________________________________
> Davinci-linux-open-source mailing list
> Davinci-linux-open-source at linux.davincidsp.com
>
http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
> 



      ____________________________________________________________________________________
Luggage? GPS? Comic books? 
Check out fitting gifts for grads at Yahoo! Search
http://search.yahoo.com/search?fr=oni_on_mail&p=graduation+gifts&cs=bz